[Openais] it seems there is a pb to use Eth brigdes with corosync ?

[Alain.Moulle]

Hi

is it supported to have one of the ringnumber with a bindnetaddr linked to
an Eth bridge if (br0) ?

because on one config, I have :
rrp_mode :       active
and
for 1st ringnumber :
         bindnetaddr: 12.1.0.0
for 2nd ringnumber :
         bindnetaddr: 12.0.0.0

and ip addr gives :

3: eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP 
qlen 1000
    link/ether 00:30:48:da:89:23 brd ff:ff:ff:ff:ff:ff
    inet 12.1.0.3/16 brd 10.1.255.255 scope global eth1
4: *br0*: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state 
UNKNOWN
    link/ether 00:30:48:da:89:22 brd ff:ff:ff:ff:ff:ff
    inet 12.0.0.3/16 brd 10.0.255.255 scope global br0

and nodes remains UNCLEAN and seem to not exchange tokens between them.

If I keep only the eth1 network, it works fine again.

So is Eth Bridge supported for corosync ?
Or is it a bug fixed in a later release ?
(this config is on fc12 and with corosync-1.1.2-1)

Thanks
Regards
Alain Moullé

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.linux-foundation.org/pipermail/openais/attachments/20100604/899dd254/attachment.htm